How To: Make A Drone (Quadcopter)

34
75

See how to use the NAZA Assistant Software to set up your flight controller: See where to …

34 COMMENTS

  1. Tip for soldering big wires to big boards: use a high powered soldering iron for the bigger joints, as you will be able to heat it up fast and not overheat stuff on the board. I used an 80 watt iron for the big connections, and a 25 watt iron for the small, precise ones.

  2. Sorry to The poster of this video but this is very important and please do not take down my comment, thanks. In the Untied States you must have a Ham radio license to fly FPV. If you do not believe me here is the link
    http://www.propwashed.com/need-amateur-radio-ham-license-fly-fpv/. I am putting this out there because if people Flying FPV in the US do not get licensed then eventually the US will ban FPV. So please if your going to fly FPV in the US get a Ham license.

  3. hi Andres ,this vedio is of a lot help to me bro,thank u can u plz tellme ,does this quad hover in air when u take ur hands of the controler or it crash lands
    2)what if it goes out of ur controller range does it keep going or hovers or crashes lands
    or come back to start point

  4. plz help me!!..i am making a quadcopter with 1400kv motors and a kk2.1.5 board and a flysky Ct6b transmitter…i am done building the quad but after when i arm it, all the rotor start to rotate at different times and after i take the throttle to the middle the kk board just restarts and show the version name and then the safe screen plz help me

LEAVE A REPLY

Please enter your comment!
Please enter your name here